Are you trying to figure out how to upgrade your HP EliteDesk 800 G6 or HP EliteOne 800 G6 with an additional 2.5” drive? You’ve come to the right place! In this guide, we will walk you through the steps to ensure you successfully add a new drive to your desktop.
First, let’s take a look at some important information. According to the HP Quickspecs, the EliteDesk 800 G6 and EliteOne 800 G6 models come with a dedicated 2.5-inch SATA drive bay, but this bay is unavailable if you have the 125W processor model. If your model supports a 2.5” drive bay, here’s how you can proceed.
Step 1: Gather Your Supplies
Before you start, make sure you have all the necessary tools and equipment. You will need:
- A compatible 2.5” SATA drive
- A screwdriver (typically a Phillips head)
- Your desktop computer (HP EliteDesk 800 G6 or EliteOne 800 G6)
Step 2: Power Down Your Computer
Your safety is important, so make sure to power down your computer and unplug it from the electrical outlet. This will prevent any potential electrical hazards while you work inside the machine.
Step 3: Open the Case
Using the screwdriver, carefully remove the screws holding the side panel of your computer case in place. Once the screws are removed, gently slide or lift the panel off to access the internal components.
Step 4: Locate the Drive Bay
Inside your HP EliteDesk or EliteOne, look for the 2.5-inch SATA drive bay. This is where you will install your new hard drive. Make sure you check if your processor model supports this bay. If you have the 125W model, you may need to consider alternative storage solutions.
Step 5: Install Your New Drive
Take your 2.5” SATA drive and carefully slide it into the drive bay. Ensure that it fits securely in the slot. Depending on the model, you may need to fasten it using screws or it might slide into place using a rail system—follow the instructions that come with your hardware if necessary.
Step 6: Make Connections
Once the drive is securely in place, locate the SATA data and power cables. Connect the SATA data cable from the motherboard to your new drive. Then, connect the power cable from the power supply unit to the drive.
Step 7: Close the Case and Power On
Now that everything is connected correctly, replace the side panel of your computer case and screw it back into place. Reconnect the power cord to your desktop and turn it on.
Step 8: Format the New Drive
After booting up, you may need to format the new drive to make it usable. Go to your computer’s disk management tool, find your new drive, and follow the prompts to format it to your desired file system (NTFS is common for Windows).
Conclusion
Congratulations! You’ve successfully added a 2.5” drive to your HP EliteDesk 800 G6 or HP EliteOne 800 G6—assuming your model allows for it. Enjoy the extra storage, and feel free to reach out if you have any questions about this process.